Plug & Play PID Temperature Controller + Timer Control Panel Box with Circuit Breaker for Kiln Oven

Specifications: Input voltage 120V (for North America) and 240V (for EU and Australia). Output voltage Same as the input. with maximum Current load of 15A. One set point temperature controller. Sensor Type Type K 6" long Kiln Thermocouple Temperature control range -50 to 1000 °C (-58 to 1832 °F) Thermocouple: K type 15 cm 6 inch long Sensor cable length 6.6 ft (2m) - Box material & Dimension ABS 200x120x75mm ( 7 3/4 x 4 3/4 x 3" ). Temperature display unit Fahrenheit (°F) and Celsius (°C). Equipped with timer - 12VDC with 2 timer cycle T1 and T2. Adaptor 12V is included. Timer Modes: P1 = 0 (Single delay with no cycle or loop): Only there is one timer T1. Relay stay disconnect (off) when T1 is counting and will become connect (on) once T1 finished counting. P1 = 1 (Single delay with no cycle or loop): Only there is one timer T1. Relay stay connect (on) when T1 is counting and will become disconnect (off) once T1 finished counting. P1 = 2 (Dual timer delay T1,T2 with no cycle or loop): Relay stay disconnect (off) when T1 is counting and will become connect (on) once T2 is counting and will be off when T2 finished counting. P1 = 3 (Dual timer delay T1,T2 with no cycle or loop): Relay stay connect (on) when T1 is counting and will become disconnect (off) once T2 is counting and will be on when T2 finished counting. P1 = 4 (Dual timer delay T1,T2 with cycle or loop): Relay stay disconnect (off) when T1 is counting and will become connect (on) once T2 is counting and it will repeat this cycle again. P1 = 5 ((Dual timer delay T1,T2 with cycle or loop): Relay stay connect (on) when T1 is counting and will become disconnect (off) once T2 is counting and it will repeat this cycle again.

• Its heavy duty kiln thermocouple can measure and control very high temperatures up to 1000C (1832 °F ) and it equipped with timer (T1 and T2)· Equipped with male and female connector, so you can easily change your thermocouple. · To operate, you only need to plug the heater to the socket wire of the controller at the back, drop the sensor into the Kiln, turn on the power of controller and adjust it to your own requirements.
• Plug and Play PID one set point Temperature controller box with 15 Amp Maximum current. Equipped with circuit breaker switch 15 Amp (instead of short life fuse) . High Measuring accuracy, ±0.2% or ±1 unit of full input range. Celsius or Fahrenheit display selected on user’s discretion. Calibration function for sensor temperature correction
• This plug and play temperature controller with 6" long thermocouple, has a wide range of applications in controlling the temperature of Kilns, Ovens, Furnaces & …. (for loading current up to 15Amp) . This is an inexpensive and heavy duty plug and play controller box. Please consider that if you need to change your sensor to specific one, I can change it for you too. It is One set point temperature controller and if you need ramp and soak please see my other products.
• Timer Modes: it has 5 timers mode and you can use one or 2 timer (T1,T2), with or without Cycle or Loop, Delay, Start with on or off relay,
• It equipped with Buzzer and Flasher Alarm for High or Low temperature alarm and also alarm for thermocouple problem